The short version of lyophilized powder fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-10-11 and is reviewed periodically as new material appears.
Supplied material is typically a lyophilized white to off-white powder. The peptide is freely soluble in water and in common aqueous buffers, which allows it to be handled as a stock solution. Because the sequence contains no cysteine, disulfide cross-linking is not a route of degradation. The absence of aromatic residues means ultraviolet absorbance at 280 nm is minimal, so quantification usually relies on peptide bond absorbance near 214 nm or on amino acid analysis.
Common synonyms in catalogs include pentadecapeptide BPC 157, BPC157, and the full sequence name. A CAS registry number in the 137525-51-0 range is frequently listed, though the assignment should be verified against the supplier certificate of analysis. The name itself is not a pharmacopoeial designation, and there is no standardized international nonproprietary name. Distinguishing genuine material from related fragments generally requires mass spectrometry, since several truncated sequences share similar chromatographic behavior.
BPC-157 is a synthetic pentadecapeptide whose sequence is commonly given as Gly-Glu-Pro-Pro-Pro-Gly-Lys-Pro-Ala-Asp-Asp-Ala-Gly-Leu-Val. It is described in the literature as a fragment of a larger protein found in human gastric juice, referred to as body protection compound. The peptide was first characterized in the early 1990s by a research group in Zagreb, Croatia. Its molecular formula is C62H98N16O22 and its monoisotopic mass is approximately 1419 daltons.
A freeze-dried sample is generally the most stable form and is commonly held at minus twenty degrees Celsius or lower for long-term keeping, with brief transfers at room temperature. The solid is hygroscopic, so vials are warmed to ambient temperature before opening to prevent condensation from degrading the contents. Light exposure and repeated temperature cycling are both avoided in routine handling. Storage over a desiccant is a common laboratory practice that limits moisture uptake during repeated access.
Once dissolved, the material is considerably less stable than the dry solid. Aqueous solutions are usually kept cold and used within a short window, and neutral or mildly acidic buffers are preferred over strongly alkaline conditions. Freeze-thaw cycles promote aggregation and loss of material to container surfaces, so dividing a batch into single-use aliquots is standard. Adsorption to plastic and glass can lower the measured concentration, meaning solution strength may need rechecking before an experiment.
Identity and purity are established with complementary methods rather than one test. Reverse-phase high-performance liquid chromatography separates the main peak from deletion sequences and oxidized variants, and its area percentage is the usual purity figure. Mass spectrometry confirms the expected molecular mass and can flag truncations or modifications that chromatography alone might miss. Amino acid analysis and peptide mapping add sequence-level confirmation, while residual counter-ion and water content are measured separately.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white lyophilized powder | Assessed by visual inspection under ordinary laboratory lighting |
| Molecular mass | Approximately 1419 Da | Monoisotopic mass for the fifteen-residue sequence |
| Solubility class | Freely soluble in water | Stock solutions commonly prepared in water or aqueous buffer |
| Typical storage temperature | -20 °C or below, desiccated | Lyophilized powder; repeated freeze-thaw cycles are usually avoided |
| Common analytical method | Reversed-phase HPLC with UV detection | Frequently paired with mass spectrometry to confirm identity |
The main chemical liabilities of this sequence are peptide-bond hydrolysis and possible aspartate-related reactions, since the peptide contains aspartic acid residues but no cysteine, methionine, or tryptophan. Absence of those three residues removes the most common oxidation and disulfide pathways from consideration. Studies of related peptides indicate that aspartate isomerisation and aspartimide formation occur most readily at Asp-Gly and Asp-Ala positions, and open questions remain about how quickly those reactions proceed under ordinary laboratory conditions. Storage guidance typically emphasises cool, dry, dark conditions to slow hydrolysis.
Identity and purity are usually assessed with reversed-phase high-performance liquid chromatography, often paired with mass spectrometry using electrospray or MALDI ionisation. Amino acid analysis and peptide mapping by enzymatic digestion provide additional sequence-level confirmation. Purity is commonly reported as an area percentage from a chromatographic trace, and water content can be measured by Karl Fischer titration. Reported masses may differ by tens of daltons between sources because preparations can contain acetate or trifluoroacetate counterions, and such differences are not by themselves evidence of a different peptide.
BPC-157 is normally distributed as a lyophilised powder that ranges from white to off-white in appearance. The peptide dissolves readily in water, normal saline, and common aqueous buffers, and it is poorly soluble in nonpolar solvents such as hexane or vegetable oils. Lyophilised vials take up moisture if left open, which changes the mass of powder in the container and complicates any later weighing. Because the material is handled in small quantities, static and adhesion to glass or plastic can also cause noticeable losses during transfer.
Proposed mechanisms include interaction with the nitric oxide system, modulation of growth factor signaling, and effects on blood vessel formation. None of these has been established as the primary mode of action, and some proposed pathways rest on indirect measurements. Whether the reported effects depend on a specific receptor has not been determined. Stability in gastric acid, unusual for a peptide of this size, is also reported in animal work, but the reason for it is not firmly established.
Published studies on BPC-157 are dominated by animal models. Commonly used endpoints include healing of surgically induced lesions in the stomach, tendon-to-bone attachment after transection, and recovery from experimentally induced vascular or intestinal damage. Many of these reports come from a small number of research groups, and the peptide is often described as acting across a wide range of tissue types. That breadth is itself a point of discussion, since one molecule influencing many unrelated systems is unusual.
Human data are far more limited than animal data. A small number of clinical reports exist, generally with few participants and without the randomization or blinding expected in later-phase trials. No large, independently replicated human trial has appeared in the indexed peer-reviewed literature. Statements about effects in people therefore rest on extrapolation from animal work rather than on direct evidence, and the strength of that extrapolation remains an open question rather than a settled matter.
Most published findings come from rodent experiments using induced injury or surgical models. Human reports remain scarce and are largely observational, which limits how much can be stated with confidence. Questions about absorption, distribution, metabolism, and clearance in people are still open. Dose translation between species is likewise unresolved. Researchers tend to read the animal literature as a starting point rather than a settled account.
BPC-157 is a synthetic peptide composed of fifteen amino acids. Its sequence corresponds to part of a protein found in human gastric juice, which is the origin of the "body protection compound" label. In laboratory work the material is treated as a defined research chemical rather than a finished product. Published research has centered on animal models, and the peptide is not an approved medicine in most countries.
== P == P24 – package insert – palliative – palliative care – pancreas – pancreatitis – pancytopenia – pandemic – pap smear – papilloma – parallel track – parasite – parenteral – paresthesia – passive immunity – passive immunotherapy – pathogen – pathogenesis – PBMC – PCP – PCR – Pediatric AIDS Clinical Trial Group (PACTG) – pelvic inflammatory disease – peptide – perianal – perinatal – perinatal transmission – peripheral neuritis – peripheral neuropathy – persistent generalized lymphadenopathy – PGL – phagocyte – phagocytosis – pharmacokinetics – phase I trials – phase II trials – phase III trials – phase IV trials – photosensitivity – PHS – pituitary gland – placebo – placebo controlled study – placebo effect – plasma – plasma cells – platelets – PML – Pneumocystis jiroveci pneumonia (formerly Pneumocystis carinii or PCP) – POL – polymerase – polymerase chain reaction (PCR) – polyneuritis – polypeptide – polyvalent vaccine – post-exposure prophylaxis (PEP) – PPD test – pre-conception counseling – preclinical – precursor cells – prevalence – primary HIV infection – primary isolate – primaquine – proctitis – prodrome – prodrug – progressive multifocal leukoencephalopathy (PML) – prophylactic drug – prophylaxis – protease – protease inhibitors – protease-sparing regimen – proteins – protocol – protozoa – provirus – pruritus – pseudo-Cushing's syndrome – pseudovirion – PUBMED – pulmonary – purified protein derivative (PPD)
== Adverse effects == Adverse drug reactions (ADRs) are rare when lidocaine is used as a local anesthetic and is administered correctly. Most ADRs associated with lidocaine for anesthesia relate to administration technique (resulting in systemic exposure) or pharmacological effects of anesthesia, and allergic reactions only rarely occur. Systemic exposure to excessive quantities of lidocaine mainly results in central nervous system (CNS) and cardiovascular effects – CNS effects usually occur at lower blood plasma concentrations and additional cardiovascular effects present at higher concentrations, though cardiovascular collapse may also occur with low concentrations. ADRs by individual organ systems are:
=== Pyrimidines === Uridine phosphorylase or pyrimidine-nucleoside phosphorylase substitutes the anomeric-carbon-bonded phosphate of ribose 1-phosphate for the free base uracil, forming the nucleoside uridine. Uridine kinase (aka uridine–cytidine kinase) can then phosphorylate the 5’-carbon of this nucleoside into uridine monophosphate (UMP). UMP/CMP kinase (EC 2.7.4.14) can phosphorylate UMP into uridine diphosphate, which nucleoside diphosphate kinase can phosphorylate into uridine triphosphate. Thymidine phosphorylase or pyrimidine-nucleoside phosphorylase adds 2-deoxy-alpha-D-ribose 1-phosphate to thymine, with thymine bonding at the anomeric carbon of the deoxyribose, forming the deoxynucleoside thymidine. Thymidine kinase can then phosphorylate the 5’-carbon of this compound into thymidine monophosphate (TMP). Thymidylate kinase can phosphorylate TMP into thymidine diphosphate, which nucleoside diphosphate kinase can phosphorylate into thymidine triphosphate. The nucleosides cytidine and deoxycytidine can be salvaged along the uracil pathway by cytidine deaminase, which converts them to uridine and deoxyuridine, respectively. Alternatively, uridine–cytidine kinase can phosphorylate them into cytidine monophosphate (CMP) or deoxycytidine monophosphate (dCMP). UMP/CMP kinase can phosphorylate (d)CMP into cytidine diphosphate or deoxycytidine diphosphate, which nucleoside diphosphate kinase can phosphorylate into cytidine triphosphate or deoxycytidine triphosphate.
Sources: en.wikipedia.org
== Role in signaling pathways == An understanding of the role of fyn in normal biology is crucial to the understanding of its role in cancer, as cancer is the dysregulation of these normal pathways. Knowing which pathways involve Fyn will provide key insight for the development of potential pharmacologic agents to attenuate this uncontrolled signaling. At least three tools have been useful in discerning a requirement for Fyn function in a particular signaling system:
Pure radium metal is isolated by reducing radium oxide with aluminium metal in a vacuum at 1,200 °C. In 1954, the total worldwide supply of purified radium amounted to about 5 pounds (2.3 kg). Zaire and Canada were briefly the largest producers of radium in the late 1970s. As of 1997 the chief radium-producing countries were Belgium, Canada, the Czech Republic, Slovakia, the United Kingdom, and Russia. The annual production of radium compounds was only about 100 g in total as of 1984; annual production of radium had reduced to less than 100 g by 2018.
Nicotine is the active chemical constituent in tobacco, which is available in many forms, including cigarettes, cigars, chewing tobacco, and smoking cessation aids such as nicotine patches, nicotine gum, and electronic cigarettes. Nicotine is used widely throughout the world for its stimulating and relaxing effects. Nicotine exerts its effects through the agonism of nicotinic acetylcholine receptors, resulting in multiple downstream effects such as increase in activity of dopaminergic neurons in the midbrain reward system, and acetaldehyde one of the tobacco constituent decreased the expression of monoamine oxidase in the brain. Nicotine is addictive and dependence-forming. Tobacco, the most common source of nicotine, has an overall harm to user and self score 3% below cocaine, and 13% above amphetamines, ranking 6th most harmful of the 20 drugs assessed, as determined by a multi-criteria decision analysis.
The 'father of modern chemistry', Antoine Lavoisier, had viewed fermentation as a simple chemical reaction and rejected the notion that living organisms could be involved. By the 19th century, this was seen as vitalism, which was lampooned in an anonymous 1839 publication by Justus von Liebig and Friedrich Wöhler. In 1837, Charles Cagniard de la Tour, Theodor Schwann and Friedrich Traugott Kützing independently published papers concluding, as a result of microscopic investigations, that yeast is a living organism that reproduces by budding. Schwann boiled grape juice to kill the yeast and found that no fermentation would occur until new yeast was added. The turning point came when Louis Pasteur (1822–1895), during the 1850s and 1860s, repeated Schwann's experiments and showed fermentation is initiated by living organisms in a series of investigations. In 1857, Pasteur showed lactic acid fermentation is caused by living organisms. In 1860, he demonstrated how bacteria cause souring in milk, a process formerly thought to be merely a chemical change. His work in identifying the role of microorganisms in food spoilage led to the process of pasteurization. In 1877, working to improve the French brewing industry, Pasteur published his famous paper on fermentation, "Etudes sur la Bière", which was translated into English in 1879 as "Studies on fermentation". He defined fermentation (incorrectly) as "Life without air".
Sources: en.wikipedia.org
It is a synthetic peptide built from fifteen amino acids, with a mass of roughly 1419 daltons. The sequence is reported to match a fragment of a protein present in human gastric juice. It is not a naturally circulating hormone.
It is normally supplied as a lyophilized powder in a sealed vial. The powder dissolves readily in water, and stock solutions are typically prepared shortly before use. Cold storage is standard laboratory practice.
The letters are generally read as shorthand for body protection compound. That label comes from the original research context rather than from formal nomenclature. No standardized nonproprietary name exists for the peptide.
Low temperature slows the chemical reactions, such as oxidation and hydrolysis, that break down a peptide chain. Water and oxygen are the main drivers of degradation, so a cold and dry environment extends usable life. Actual shelf life depends on the batch, the salt form, and the container.